How do you convert gas rate to metric meter?
How do you convert gas rate to metric meter?
Metric Gas Rate Instructions: Turn on the appliance to its maximum setting and let it run for 10 minutes. Record the first meter reading from R1. Record the second meter reading from R2 after exactly 2 minutes (160 seconds). Subtract R2-R1 and divide it by 2 to get the gas rating over 1 minute.
How do you read a secure gas meter?
How do I read my Secure smart meter?
- Press 6 on the keypad.
- You’ll see the letters “IMP R01” appear on the screen.
- Wait a moment – then eight digits will appear, followed by “kWh” towards the bottom right of the screen.
- Take the first 7 digits – this is your reading.
How do you read a smart meter with A and B button?
If your meter has A and B buttons under the screen
- press the A button.
- press the A button again until you see ‘METER INDEX’ and numbers followed by ‘M3’
- write down the number from left to right.
- ignore any zeroes at the beginning and any numbers after the decimal point.
What is the gas rate calculation?
So to calculate the hourly consumption, the gas rate for 1 minute is multiplied by the number of minutes in an hour. We can convert this figure to cubic feet by multiplying the figure by 35.37.
How do you measure gas flow rate?
The most common device for measuring a volumetric flow rate is a bubble flowmeter. These devices are used to determine flow by measuring the time required for a gas stream to move a soap bubble through a specific volume. The most basic configuration of a bubble flowmeter is illustrated in Figure 1.
What is meter index on gas meter?
Getting a reading on a digital meter Once the screen’s loaded, press the red button ‘A’ twice. You should see a screen that says ‘Meter Index’ – this is your meter reading.
What are the A and B buttons on my gas smart meter?
If your meter has an ‘A’ and ‘B’ button, press ‘A’ until you get to TOTAL ACT IMPORT. The number below this is your electricity reading. Your meter might have three buttons to the side of the display. If this is the case, just press the middle button, and the display will show your reading below the ‘IMP’ on screen.